The 246C single channel, single readout power supply is designed to control and display any flow transducer. The flow rate set point can be adjusted either through front panel controls or remotely through the rear panel analog interface. The unit supplies ±15 VDC power. The 246C Single-Channel Power Supply/Readout is for use with MKS Instruments models 358, 558, 1150, 1359, 1559, 1179, 1479.
Representative image only
246C Single-Channel MFC Power Supply Readout
TypePower Supply/Readout
Display3.5-digit 0.56 inch red LED, continuous display
Channels1
Input Signal1 x 0 - 5 VDC
Gas Correction Factor0.1 - 4.0
External Set Point0 - 5 VDC
External ON/OFFTTL-compatible
Unscaled Signal Output1 x 0 - 5 VDC = 0 - 100% of Full Scale
Scaled Signal Output0 - 2 VDC (max.)
Power Supply Output±15 VDC at 0.5 Amp, max. ripple < 10 mV
Power requirements117/234 VAC ±15%, 50-60 Hz 117/234
For Use WithMKS 179, 180, 579, 1179, 1479, 1480, 1559, 1579, 2179, M10M, M100
Signal Output Minimum Load Impedance10 kOhm/channel
246C manual
MKS Mass Flow Control Accessories data sheet
Overview
The 246C single channel, single readout power supply is designed to control and display any flow transducer. The flow rate set point can be adjusted either through front panel controls or remotely through the rear panel analog interface. The unit supplies ±15 VDC power. The 246C Single-Channel Power Supply/Readout is for use with MKS Instruments models 358, 558, 1150, 1359, 1559, 1179, 1479.